Chapter 6 Broadband
SBG3500-N Series User’s Guide
114
6.3 The 3G WAN Screen
Use this screen to configure your 3G settings. Click Network Setting > Broadband > 3G WAN.
Note: The actual data rate you obtain varies depending the 3G card you use, the signal
strength to the service provider’s base station, and so on.
Maximum Burst
Size
Maximum Burst Size (MBS) refers to the maximum number of cells that can be sent at the
peak rate. Type the MBS, which is less than 65535.
This field is available only when you select Non Realtime VBR or Realtime VBR.
QoS
Rate Limit Enter the rate limit for the connection. This is the maximum transmission rate allowed for
traffic on this connection.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 10 Bridge Mode (ADSL over ATM) (continued)
LABEL DESCRIPTION
To Next Page
Loading...
