Chapter 17 Firewall
SBG3500-N Series User’s Guide
258
17.5.1 Add/Edit an ACL Rule
Click Add new ACL rule or the Edit icon next to an existing ACL rule in the Access Control
screen. The following screen displays.
Figure 128 Access Control: Add/Edit
The following table describes the labels in this screen.
Action This is the policy of the access control. Choose the following option from the drop-down list:
Select Drop to silently discard the packets without sending a TCP reset packet or an ICMP
destination-unreachable message to the sender.
Select Reject to deny the packets and send a TCP reset packet (for a TCP packet) or an
ICMP destination-unreachable message (for a UDP packet) to the sender.
Select Accept to allow the passage of the packets.
Modify Click the Edit icon to edit the rule.
Click the Delete icon to delete an existing rule. Note that subsequent rules move up by one
when you take this action.
Click the Move To icon to change the order of the rule. Enter the number in the # field.
Table 89 Security > Firewall > Access Control (continued)
LABEL DESCRIPTION
Table 90 Access Control: Add/Edit
LABEL DESCRIPTION
Enable Click the check box to activate the ACL.
Logging Click the check box if you want to log the packet throughput in this ACL.
Filter Name Enter a descriptive name of up to 16 alphanumeric characters, not including spaces,
underscores, and dashes.
You must enter the filter name to add an ACL rule. This field is read-only if you are editing
the ACL rule.
To Next Page
Loading...
