Chapter 9 Routing
SBG3500-N Series User’s Guide
182
9.3.1 Add/Edit Policy Forwarding
Click Add new Policy Forward Rule in the Policy Forwarding screen or click the Edit icon next
to a policy. Use this screen to configure the required information for a policy route.
Figure 73 Policy Forwarding: Add/Edit
The following table describes the labels in this screen.
Policy Name This is the name of the rule.
Source IP This is the source IP address.
Source Subnet
Mask
This is the source subnet mask address.
Protocol This is the transport layer protocol.
Source Port This is the source port number.
Source MAC This is the source MAC address
Destination IP This is the destination IP address.
Destination
Subnet Mask
This is the destination subnet mask address.
Destination
Port
This is the destination port number.
Destination
MAC
This is the destination MAC address.
WAN This is the WAN interface through which the traffic is routed.
Modify Click the Edit icon to edit this policy.
Click the Delete icon to remove a policy from the SBG3500-N Series. A window displays
asking you to confirm that you want to delete the policy.
Table 40 Network Setting > Routing >Policy Forwarding (continued)
LABEL DESCRIPTION
Table 41 Policy Forwarding: Add/Edit (Sheet 1 of 2)
LABEL DESCRIPTION
Policy Name Enter a descriptive name of up to 8 printable English keyboard characters, not including
spaces.
Source IP Enter the source IP address.
To Next Page
Loading...
