Chapter 23 PPTP VPN
SBG3500-N Series User’s Guide
295
23.3 PPTP VPN Setup
Use this screen to configure settings for a Point to Point Tunneling Protocol (PPTP) server.
Click VPN > PPTP VPN to open the Setup screen as shown next.
Figure 153 VPN > PPTP VPN > Setup
This screen contains the following fields:
Table 112 VPN > PPTP VPN > Setup
LABEL DESCRIPTION
PPTP Setup
Enable Use this field to turn the SBG3500-N Series’S PPTP VPN function on or off.
Local WAN Interface Select an interface from the drop-down list and its IP address will be shown. This is the
WAN interface upon which PPTP VPN listens to a client’s connection request.
IP Address Pool Enter the pool of IP addresses that the SBG3500-N Series uses to assign to the PPTP
VPN clients.
Note: This is with a 24-bit netmask and should not conflict with any configured WAN,
LAN, DMZ, WLAN, or L2TP VPN subnet even if they are not in use.
Access Group
(Optional)
Specify up to 2 LAN groups (subnets) which a PPTP VPN client is allowed to access. If
none is specified, all LAN groups can be accessed. Enter the IP address and subnet
mask for the LAN group(s).
To Next Page
Loading...
