Chapter 13 AP Control
SBG3500-N Series User’s Guide
223
The following table describes the fields in this screen.
13.3 The Managed AP List Screen
Use this screen to manage all of the APs connected to the SBG3500-N Series. Click Network
Setting > AP Control > Managed AP List to access this screen.
Figure 102 Network Setting > AP Control > Managed AP List
The following table describes the fields in this screen.
Table 68 Network Setting > AP Control > Controller
LABEL DESCRIPTION
Enable Click the check box to enable AP Controller in the SBG3500-N Series.
Registration
Type
Select Manual to add each AP to the SBG3500-N Series for management, or Always
Accept to automatically add APs to the SBG3500-N Series for management.
Note: Select the manual option for managing a specific set of APs. This is recommended as
the registration mechanism cannot automatically differentiate between friendly and rogue
APs.
APs must be connected to the SBG3500-N Series by a wired connection or network.
Apply Click Apply to save your changes to the SBG3500-N Series.
Cancel Click Cancel to abandon the changes to the SBG3500-N Series.
Table 69 Network Setting > AP Control > Managed AP List
LABEL DESCRIPTION
# This is the AP’s index number.
IP This field displays the IP address of the AP.
MAC This field displays the MAC address of the AP.
Model This field displays the AP’s hardware model information. It displays N/A (not applicable)
only when the AP disconnects from the SBG3500-N Series and the information is
unavailable as a result.
R1 Profile This field displays the operating mode (AP) and AP profile name for Radio 1. It displays N/
A for the profile for a radio not using an AP profile.
R2 Profile This field displays the operating mode (AP) and AP profile name for Radio 2. It displays N/
A for the profile for a radio not using an AP profile.
AC Mgmt VLAN This displays the Access Controller (the SBG3500-N Series) management VLAN ID setting
for the AP.
AP Mgmt VLAN This displays the runtime management VLAN ID setting on the AP. VLAN Conflict displays if
the AP’s management VLAN ID does not match the Mgmnt. VLAN ID(AC). This field
displays N/A if the SBG3500-N Series cannot get VLAN information from the AP.
To Next Page
Loading...
