ZyXEL Communications SBG3500-N000 - The Dynamic DNS Screen

Chapter 12 Dynamic DNS Setup
SBG3500-N Series User’s Guide
221
The following table describes the labels in this screen.
12.3 The Dynamic DNS Screen
Use this screen to change your SBG3500-N Series’s DDNS. Click Network Setting > DNS >
Dynamic DNS. The screen appears as shown.
Figure 100 Network Setting > DNS > Dynamic DNS
The following table describes the fields in this screen.
Table 66 DNS Entry: Add/Edit
LABEL DESCRIPTION
FQDN Enter the Fully Qualified Domain Name (FQDN) of the DNS entry. For example, if your
hostname is myhost and a parent domain name is example.com, then your FQDN is
myhost.example.com.
IP Address Enter the IP address of the DNS entry.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 67 Network Setting > DNS > > Dynamic DNS
LABEL DESCRIPTION
Dynamic DNS Select Enable to use dynamic DNS.
Service
Provider
Select your Dynamic DNS service provider from the drop-down list box.
Hostname Type the domain name assigned to your SBG3500-N Series by your Dynamic DNS provider.
You can specify up to two host names in the field separated by a comma (",").
Username Type your user name.
Password Type the password assigned to you.
Email If you select TZO in the Service Provider field, enter the user name you used to register
for this service.
Key If you select TZO in the Service Provider field, enter the password you used to register for
this service.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.