Chapter 13 AP Control
SBG3500-N Series User’s Guide
225
13.5 The Dynamic Channel Selection Screen
Use this screen to have the SBG3500-N Series automatically choose the radio channels with the least
interference for the managed APs or you can choose the radio channels manually. There are two
frequency bands to choose from, 2.4 GHz and 5 GHz. Click Network Setting > AP Control >
DCS to access this screen.
Figure 104 Network Setting > AP Control > DCS
Disassociate
station when
overloaded
Select this option to disassociate wireless clients connected to the AP when it becomes
overloaded. If you do not enable this option, then the AP simply delays the connection until
it can afford the bandwidth it requires, or it transfers the connection to another AP within its
broadcast radius.
The disassociation priority is determined automatically by the SBG3500-N Series and is as
follows:
• Idle Timeout - Devices that have been idle the longest will be disassociated first. If
none of the connected devices are idle, then the priority shifts to Signal Strength.
• Signal Strength - Devices with the weakest signal strength will be disassociated first.
Note: If you enable this function, you should ensure that there are multiple APs within the
broadcast radius that can accept any rejected or kicked wireless clients; otherwise, a
wireless client attempting to connect to an overloaded AP will be kicked continuously
and never be allowed to connect.
Apply Click Apply to save your changes to the SBG3500-N Series.
Cancel Click Cancel to exit this screen without saving your changes.
Table 70 Network Setting > AP Control > Load Balancing (continued)
LABEL DESCRIPTION
To Next Page
Loading...
