Chapter 9 Routing
SBG3500-N Series User’s Guide
183
9.4 The RIP Screen
Routing Information Protocol (RIP, RFC 1058 and RFC 1389) allows a device to exchange routing
information with other routers.
Click Network Setting > Routing > RIP to open the RIP screen.
Figure 74 RIP
The following table describes the labels in this screen.
Source Subnet
Mask
Enter the source subnet mask address.
Protocol Select the transport layer protocol (TCP or UDP).
Source Port Enter the source port number.
Source MAC Enter the source MAC address.
Destination IP Enter the destination IP address.
Destination
Subnet Mask
Enter the destination subnet mask address.
Destination Port Enter the destination port.
Destination
MAC
Enter the destination MAC address.
WAN Select a WAN interface through which the traffic is sent. You must have the WAN
interface(s) already configured in the Broadband screens.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 41 Policy Forwarding: Add/Edit (Sheet 2 of 2)
LABEL DESCRIPTION
Table 42 Network Setting > Routing > RIP
LABEL DESCRIPTION
# This is the index number of the entry.
Interface This is the name of the interface in which the RIP setting is used.
Version The RIP version controls the format and the broadcasting method of the RIP packets that
the SBG3500-N Series sends (it recognizes both formats when receiving). RIP version 1 is
universally supported but RIP version 2 carries more information. RIP version 1 is
probably adequate for most networks, unless you have an unusual network topology.
Operation Select Passive to have the SBG3500-N Series update the routing table based on the RIP
packets received from neighbors but not advertise its route information to other routers in
this interface.
Select Active to have the SBG3500-N Series advertise its route information and also
listen for routing updates from neighboring routers.
To Next Page
Loading...
