Chapter 6 Broadband
SBG3500-N Series User’s Guide
119
The following table describes the labels in this screen.
6.5 The Advanced Screen
Use the Advanced screen to enable or disable DSL bonding, PTM over ADSL, Annex M, and DSL
PhyR functions. The SBG3500-N Series supports the PhyR retransmission scheme. PhyR is a
retransmission scheme designed to provide protection against noise on the DSL line. It improves
voice, video and data transmission resilience by utilizing a retransmission buffer.
Click Network Setting > Broadband > Advanced to display the following screen.
Figure 29 Network Setting > Broadband > Advanced
The following table describes the labels in this screen.
Table 13 Add 3G Dongle Information
LABEL DESCRIPTION
Default VID Enter the default vendor ID of the 3G dongle.
Default PID Enter the default product ID of the 3G dongle.
Target VID Enter the target vendor ID of the 3G dongle.
Target PID Enter the target product ID of the 3G dongle.
Port Number Enter the specified device port of the 3G dongle.
Class Enter the target device class of the 3G dongle.
Message
Content
Enter the input message content of the 3G dongle.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 14 Network Setting > Network Setting > Advanced
LABEL DESCRIPTION
State Select Enable to activate DSL bonding state and use both DSL1 and DSL2 ports at the same
time to increase data transfer rate.
PTM over ADSL Select Enable to use PTM over ADSL. Since PTM has less overhead than ATM, some ISPs
use PTM over ADSL for better performance.
Annex M You can enable Annex M for the SBG3500-N Series to use double upstream mode to
increase the maximum upstream transfer rate.
To Next Page
Loading...
