Chapter 22 IPSec VPN
SBG3500-N Series User’s Guide
286
The following table describes the labels in this screen.
22.6 The Radius Screen
Use the Radius screen to manage the list of RADIUS servers the SBG3500-N Series can use in
authenticating users. In the Web Configurator, click VPN > IPSec VPN > Radius.
Figure 147 VPN > IPSec VPN > Radius
The following table describes the labels in this screen.
Table 105 VPN > IPSec VPN > Monitor
LABEL DESCRIPTION
Radio Buttons Click the radio button to choose the VPN client you want to connect or disconnect.
Name This field displays the identification name for this IPSec VPN policy.
Status This field displays whether the IPSec VPN connection is up (yellow bulb) or down (gray
bulb).
Application Scenario This field displays the encryption algorithm used for an SA.
Remote Gateway
Address
This is the WAN IP address of the remote IPSec Gateway device.
Local Gateway
Address
This is the WAN IP address of the local IPSec Gateway device.
Connect Click this to connect.
Disconnect Click this to disconnect.
Table 106 VPN > IPSec VPN > Radius
LABEL DESCRIPTION
Radius Setup
Server Address Enter the address of the RADIUS server.
Authentication Port Specify the port number on the RADIUS server to which the SBG3500-N Series sends
authentication requests. Enter a number between 1 and 65535.
Backup Server
Address
If the RADIUS server has a backup server, enter its address here.
Backup
Authentication Port
Specify the port number on the RADIUS server to which the SBG3500-N Series sends
authentication requests. Enter a number between 1 and 65535.
To Next Page
Loading...
