ZyXEL Communications SBG3500-N000 - Example 3: Configuring a Site-To-Site with Dynamic Peer Rule; Example 4: Configuring a Remote Access Rule

Chapter 4 Tutorials
SBG3500-N Series User’s Guide
68
3 You can see the new IPSec VPN rule you’ve just created in the VPN > IPSec VPN > Monitor
screen.
4.13.3 Example 3: Configuring a Site-to-Site with Dynamic Peer Rule
Select Site-to-Site with Dynamic Peer in the Application Scenario field in the General
section. Other parameters are the same as example 1’s.
4.13.4 Example 4: Configuring a Remote Access Rule
Select Remote Access in the Application Scenario field in the General section. Other
parameters are the same as example 1’s.
Note: The Peer Gateway Address is not shown in the screen because it is an unknown
IP address to the remote access VPN client.