Chapter 7 Wireless
SBG3500-N Series User’s Guide
143
7.6 The WMM Screen
Use this screen to enable Wi-Fi MultiMedia (WMM) and WMM Power Save in wireless networks for
multimedia applications.
Click Network Setting > Wireless > WMM. The following screen displays.
Figure 43 Network Setting > Wireless > WMM
Connect Click this button to add another WPS-enabled wireless device (within wireless range of the
SBG3500-N Series) to your wireless network. This button may either be a physical button
on the outside of device, or a menu button similar to the Connect button on this screen.
Note: You must press the other wireless device’s WPS button within two minutes of pressing
this button.
Method 2 Use this section to set up a WPS wireless network by entering the PIN of the client into the
SBG3500-N Series.
Register Enter the PIN of the device that you are setting up a WPS connection with and click
Register to authenticate and add the wireless device to your wireless network.
You can find the PIN either on the outside of the device, or by checking the device’s
settings.
Note: You must also activate WPS on that device within two minutes to have it present its PIN
to the SBG3500-N Series.
Method 3 Use this section to set up a WPS wireless network by entering the PIN of the SBG3500-N
Series into the client.
Release
Configuratio
n
The default WPS status is configured.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the SBG3500-N Series.
Generate
New PIN
Number
The PIN (Personal Identification Number) of the SBG3500-N Series is shown here. Enter this
PIN in the configuration utility of the device you want to connect to using WPS.
The PIN is not necessary when you use WPS push-button method.
Click the Generate New PIN Number button to have the SBG3500-N Series create a new
PIN.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
Table 27 Network Setting > Wireless > WPS (continued)
LABEL DESCRIPTION
To Next Page
Loading...
