ZyXEL Communications SBG3500-N000 - OAM Ping Test

Chapter 42 Diagnostic
SBG3500-N Series User’s Guide
349
Figure 192 Maintenance > Diagnostic > 802.1ag
The following table describes the fields in this screen.
42.5 OAM Ping Test
Click Maintenance > Diagnostic > OAM Ping Test to open the screen shown next. Use this
screen to perform an OAM (Operation, Administration and Maintenance) F4 or F5 loopback test on a
Table 146 Maintenance > Diagnostic > 802.1ag
LABEL DESCRIPTION
802.1ag Connectivity Fault Management
Maintenance
Domain (MD) Level
Select a level (0-7) under which you want to create an MA.
Destination MAC
Address
Enter the target device’s MAC address to which the SBG3500-N Series performs a CFM
loopback test.
802.1Q VLAN ID Type a VLAN ID (0-4095) for this MA.
VDSL Traffic Type This shows whether the VDSL traffic is activated.
Loopback Message
(LBM)
This shows how many Loop Back Messages (LBMs) are sent and if there is any inorder
or outorder Loop Back Response (LBR) received from a remote MEP.
Linktrace Message
(LTM)
This shows the destination MAC address in the Link Trace Response (LTR).
Set MD Level Click this button to configure the MD (Maintenance Domain) level.
Send Loopback Click this button to have the selected MEP send the LBM (Loop Back Message) to a
specified remote end point.
Send Linktrace Click this button to have the selected MEP send the LTMs (Link Trace Messages) to a
specified remote end point.