Chapter 4 Tutorials
SBG3500-N Series User’s Guide
43
Thomas can now use the WPS feature to establish a wireless connection between his notebook and
the SBG3500-N Series (see Section 4.5.2 on page 43). He can also use the notebook’s wireless
client to search for the SBG3500-N Series (see Section 4.5.3 on page 47).
4.5.2 Using WPS
This section shows you how to set up a wireless network using WPS. It uses the SBG3500-N Series
as the AP and ZyXEL NWD210N as the wireless client which connects to the notebook.
Note: The wireless client must be a WPS-aware device (for example, a WPS USB adapter
or PCMCIA card).
There are two WPS methods to set up the wireless client settings:
• Push Button Configuration (PBC) - simply press a button. This is the easier of the two
methods.
• PIN Configuration - configure a Personal Identification Number (PIN) on the SBG3500-N
Series. A wireless client must also use the same PIN in order to download the wireless network
settings from the SBG3500-N Series.
Push Button Configuration (PBC)
1 Make sure that your SBG3500-N Series is turned on and your notebook is within the cover range of
the wireless signal.
2 Make sure that you have installed the wireless client driver and utility in your notebook.
3 In the wireless client utility, go to the WPS setting page. Enable WPS and press the WPS button
(Start or WPS button).
4 Log into SBG3500-N Series’s web configurator and go to the Network Setting > Wireless > WPS
screen. Enable the WPS function and click Apply. Then click the Connect button.
Note: You must enable the Wireless function in the Network Setting > Wireless >
General screen before you can enable the WPS function.
To Next Page
Loading...
