Chapter 7 Wireless
SBG3500-N Series User’s Guide
135
Your SBG3500-N Series allows you to configure up to four 64-bit or 128-bit WEP keys but only one
key can be enabled at any one time.
In order to configure and enable WEP encryption, click Network Setting > Wireless to display the
General screen, then select Basic as the security level.
Figure 36 Wireless > General: Basic (WEP)
The following table describes the labels in this screen.
Table 21 Wireless > General: Basic (WEP)
LABEL DESCRIPTION
Security Level Select Basic to enable WEP data encryption.
Generate
password
automatically
Select this option to have the SBG3500-N Series automatically generate a password. The
password field will not be configurable when you select this option.
Password 1~4 The password (WEP keys) are used to encrypt data. Both the SBG3500-N Series and the
wireless stations must use the same password (WEP key) for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal characters
("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal characters
("0-9", "A-F").
You must configure at least one password, only one password can be activated at any one
time. The default password is Passowrd 1.
more.../less Click more... to show more fields in this section. Click less to hide them.
WEP Encryption Select 64-bits or 128-bits.
This dictates the length of the security key that the network is going to use.
To Next Page
Loading...
