Chapter 35 TR-069 Client
SBG3500-N Series User’s Guide
331
The following table describes the fields in this screen.
Table 137 Maintenance > TR-069 Client
LABEL DESCRIPTION
Inform Select Enable for the SBG3500-N Series to send periodic inform via TR-069 on the
WAN. Otherwise, select Disable.
Inform Interval Enter the time interval (in seconds) at which the SBG3500-N Series sends information
to the auto-configuration server.
ACS URL Enter the URL or IP address of the auto-configuration server.
ACS User Name Enter the TR-069 user name for authentication with the auto-configuration server.
ACS Password Enter the TR-069 password for authentication with the auto-configuration server.
WAN Interface used
by TR-069 client
Select a WAN interface through which the TR-069 traffic passes.
If you select Any_WAN, you should also select the pre-configured WAN connection(s).
Display SOAP
messages on serial
console
Select Enable to show the SOAP messages on the console.
Connection Request
Authentication
Select this option to enable authentication when there is a connection request from the
ACS.
Connection Request
User Name
Enter the connection request user name.
When the ACS makes a connection request to the SBG3500-N Series, this user name is
used to authenticate the ACS.
Connection Request
Password
Enter the connection request password.
When the ACS makes a connection request to the SBG3500-N Series, this password is
used to authenticate the ACS.
Connection Request
URL
This shows the connection request URL.
The ACS can use this URL to make a connection request to the SBG3500-N Series.
Local certificate
used by TR-069
client
You can choose a local certificate used by TR-069 client. The local certificate should be
imported in the Security > Certificates > Local Certificates screen.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
