Chapter 40 Firmware Upgrade
SBG3500-N Series User’s Guide
343
After you see the firmware updating screen, wait two minutes before logging into the SBG3500-N
Series again.
Figure 182 Firmware Uploading
The SBG3500-N Series automatically restarts in this time causing a temporary network disconnect.
In some operating systems, you may see the following icon on your desktop.
Figure 183 Network Temporarily Disconnected
After two minutes, log in again and check your new firmware version in the Status screen.
If the upload was not successful, the following screen will appear. Click OK to go back to the
Firmware Upgrade screen.
Figure 184 Error Message
To Next Page
Loading...
