Chapter 4 Tutorials
SBG3500-N Series User’s Guide
52
In the following figure, router R is connected to the SBG3500-N Series’s LAN. R connects to two
networks, N1 (192.168.1.x/24) and N2 (192.168.10.x/24). If you want to send traffic from
computer A (in N1 network) to computer B (in N2 network), the traffic is sent to the SBG3500-N
Series’s WAN default gateway by default. In this case, B will never receive the traffic.
You need to specify a static routing rule on the SBG3500-N Series to specify R as the router in
charge of forwarding traffic to N2. In this case, the SBG3500-N Series routes traffic from A to R
and then R routes the traffic to B.
This tutorial uses the following example IP settings:
Table 4 IP Settings in this Tutorial
DEVICE / COMPUTER IP ADDRESS
The SBG3500-N Series’s WAN 172.16.1.1
The SBG3500-N Series’s LAN 192.168.1.1
IP Type IPv4
Use Interface ADSL/atm0
A 192.168.1.34
To Next Page
Loading...
