Chapter 7 Tutorials
ZyWALL USG 100/200 Series User’s Guide
144
7.5.1 Set Up the VPN Gateway
The VPN gateway manages the IKE SA. You do not have to set up any other
objects before you configure the VPN gateway because this VPN tunnel does not
use any certificates or extended authentication.
1 Click Configuration > VPN > IPSec VPN > VPN Gateway, and then click the
Add icon.
2 Enable the VPN gateway and name it (“VPN_GW_EXAMPLE”). For My Address,
select Interface and wan1. For the Peer Gateway Address, select Static
Address and enter 2.2.2.2 in the Primary field. For the Authentication, Select
Pre-Shared Key and enter 12345678. Click OK.
Figure 98 Configuration > VPN > IPSec VPN > VPN Gateway > Add
7.5.2 Set Up the VPN Connection
The VPN connection manages the IPSec SA. You have to set up the address
objects for the local network and remote network before you can set up the VPN
connection.
To Next Page
Loading...
