ZyXEL Communications USG-100@USG-200 - V2.20 ED 2 - The HTTP Redirect Edit Screen

Chapter 20 HTTP Redirect
ZyWALL USG 100/200 Series User’s Guide
436
20.2.1 The HTTP Redirect Edit Screen
Click Network > HTTP Redirect to open the HTTP Redirect screen. Then click
the Add or Edit icon to open the HTTP Redirect Edit screen where you can
configure the rule.
Figure 325 Network > HTTP Redirect > Edit
The following table describes the labels in this screen.
Port This is the service port number used by the proxy server.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to return the screen to its last-saved settings.
Table 110 Configuration > Network > HTTP Redirect (continued)
LABEL DESCRIPTION
Table 111 Network > HTTP Redirect > Edit
LABEL DESCRIPTION
Enable Use this option to turn the HTTP redirect rule on or off.
Name Enter a name to identify this rule. You may use 1-31 alphanumeric
characters, underscores(_), or dashes (-), but the first character cannot
be a number. This value is case-sensitive.
Interface Select the interface on which the HTTP request must be received for the
ZyWALL to forward it to the specified proxy server.
Proxy Server Enter the IP address of the proxy server.
Port Enter the port number that the proxy server uses.
OK Click OK to save your changes back to the ZyWALL.
Cancel Click Cancel to exit this screen without saving.