Chapter 40 User/Group
ZyWALL USG 100/200 Series User’s Guide
748
40.4.2 User Aware Login Example
Access users cannot use the Web Configurator to browse the configuration of the
ZyWALL. Instead, after access users log into the ZyWALL, the following screen
appears.
Figure 493 Web Configurator for Non-Admin Users
The following table describes the labels in this screen.
Table 201 Web Configurator for Non-Admin Users
LABEL DESCRIPTION
User-defined
lease time
(max ...
minutes)
Access users can specify a lease time shorter than or equal to the one
that you specified. The default value is the lease time that you specified.
Renew Access users can click this button to reset the lease time, the amount of
time remaining before the ZyWALL automatically logs them out. The
ZyWALL sets this amount of time according to the
• User-defined lease time field in this screen
• Lease time field in the User Add/Edit screen (see Section 40.2.1
on page 738)
• Lease time field in the Setting screen (see Section 40.4 on page
743)
Updating lease
time
automatically
This box appears if you checked the Allow renewing lease time
automatically box in the Setting screen. (See Section 40.4 on page
743.) Access users can select this check box to reset the lease time
automatically 30 seconds before it expires. Otherwise, access users have
to click the Renew button to reset the lease time.
Remaining
time before
lease timeout
This field displays the amount of lease time that remains, though the
user might be able to reset it.
Remaining
time before
auth. timeout
This field displays the amount of time that remains before the ZyWALL
automatically logs the access user out, regardless of the lease time.
To Next Page
Loading...
