ZyXEL Communications USG-100@USG-200 - V2.20 ED 2 - The Zone Screen

Chapter 17 Zones
ZyWALL USG 100/200 Series User’s Guide
415
17.2 The Zone Screen
The Zone screen provides a summary of all zones. In addition, this screen allows
you to add, edit, and remove zones. To access this screen, click Configuration >
Network > Zone.
Figure 313 Configuration > Network > Zone
The following table describes the labels in this screen.
Table 103 Configuration > Network > Zone
LABEL DESCRIPTION
User
Configuration /
System
Default
The ZyWALL comes with pre-configured System Default zones that you
cannot delete. You can create your own User Configuration zones
Add Click this to create a new, user-configured zone.
Edit Double-click an entry or select it and click Edit to open a screen where
you can modify the entry’s settings.
Remove To remove a user-configured trunk, select it and click Remove. The
ZyWALL confirms you want to remove it before doing so.
Object
References
Select an entry and click Object References to open a screen that
shows which settings use the entry. See Section 13.3.2 on page 312 for
an example.
# This field is a sequential value, and it is not associated with any
interface.
Name This field displays the name of the zone.
Block Intra-
zone
This field indicates whether or not the ZyWALL blocks network traffic
between members in the zone.
Member This field displays the names of the interfaces that belong to each zone.