Chapter 1 Introducing the ZyWALL
ZyWALL USG 100/200 Series User’s Guide
36
1.3.1 Front Panel LEDs
The following table describes the LEDs.
1.4 Management Overview
You can use the following ways to manage the ZyWALL.
Table 1 Front Panel LEDs
LED COLOR STATUS DESCRIPTION
PWR Off The ZyWALL is turned off.
Green On The ZyWALL is turned on.
Red On There is a hardware component failure. Shut down
the device, wait for a few minutes and then restart
the device (see Section 1.5 on page 38). If the LED
turns red again, then please contact your vendor.
SYS Green Off The ZyWALL is not ready or has failed.
On The ZyWALL is ready and running.
Flashing The ZyWALL is restarting.
AUX Green Off The AUX port is not connected.
Flashing The AUX port is sending or receiving packets.
On The AUX port is connected.
P1, P2, ... Green Off There is no traffic on this port.
Flashing The ZyWALL is sending or receiving packets on this
port.
Orange Off There is no connection on this port.
On This port has a successful link.
Card Green Off There is no card in the slot.
On There is a card in the slot.
Flashing The card in the slot is sending or receiving traffic.
To Next Page
Loading...
