ZyWALL USG 100/200 Series User’s Guide
919
CHAPTER 54
Reboot
54.1 Overview
Use this to restart the device (for example, if the device begins behaving
erratically). See also Section 1.5 on page 38 for information on different ways to
start and stop the ZyWALL.
54.1.1 What You Need To Know
If you applied changes in the Web configurator, these were saved automatically
and do not change when you reboot. If you made changes in the CLI, however,
you have to use the write command to save the configuration before you reboot.
Otherwise, the changes are lost when you reboot.
Reboot is different to reset; (see Section 56.1 on page 940) reset returns the
device to its default configuration.
54.2 The Reboot Screen
The Reboot screen is part of the Web configurator so that remote users can
restart the device. To access this screen, click Maintenance > Reboot.
Figure 607 Maintenance > Reboot
Click the Reboot button to restart the ZyWALL. Wait a few minutes until the login
screen appears. If the login screen does not appear, type the IP address of the
device in your Web browser.
You can also use the CLI command reboot to restart the ZyWALL.
To Next Page
Loading...
