ZyXEL Communications USG-100@USG-200 - V2.20 ED 2 - Application Patrol Statistics; Application Patrol Statistics: General Setup

Chapter 10 Monitor
ZyWALL USG 100/200 Series User’s Guide
261
10.12 Application Patrol Statistics
This screen displays a bandwidth usage graph and statistics for selected protocols.
Click Monitor > AppPatrol Statistics to open the following screen.
10.12.1 Application Patrol Statistics: General Setup
Use the top of the Monitor > AppPatrol Statistics screen to configure what to
display.
Figure 244 Monitor > AppPatrol Statistics: General Setup
Status Ready - you can have the ZyWALL use the USB storage device.
Click Remove Now to stop the ZyWALL from using the USB storage
device so you can remove it.
Unused - the connected USB storage device was manually unmounted
by using the Remove Now button or for some reason the ZyWALL
cannot mount it.
Click Use It to have the ZyWALL mount a connected USB storage
device.
none - no USB storage device is connected.
Detail This field displays any other information the ZyWALL retrieves from the
USB storage device.
Deactivated - the use of a USB storage device is disabled (turned off)
on the ZyWALL.
OutofSpace - the available disk space is less than the disk space full
threshold (see Section 50.3 on page 831 for how to configure this
threshold).
Mounting - the ZyWALL is mounting the USB storage device.
Removing - the ZyWALL is unmounting the USB storage device.
none - the USB device is operating normally or not connected.
Table 41 Monitor > System Status > USB Storage (continued)
LABEL DESCRIPTION