ZyXEL Communications USG-100@USG-200 - V2.20 ED 2 - Configuring Dial-In Mgmt

Chapter 50 System
ZyWALL USG 100/200 Series User’s Guide
875
Hang Up check box is selected, the ZyWALL uses this hardware signal to force the
WAN device to hang up, in addition to issuing the drop command ATH.
Response Strings
The response strings tell the ZyWALL the tags, or labels, immediately preceding
the various call parameters sent from the serial modem. The response strings
have not been standardized; please consult the documentation of your serial
modem to find the correct tags.
50.12.1 Configuring Dial-in Mgmt
Click Configuration > System > Dial-in Mgmt to display the following screen.
Configure this screen for dial-in management connections.
Figure 578 Configuration > System > Dial-in Mgmt
The following table describes the labels in this screen.
Table 252 Configuration > System > Dial-in Mgmt
LABEL DESCRIPTION
Show Advance
Settings / Hide
Advance Settings
Click this button to display a greater or lesser number of configuration
fields.
Dial-in Server
Properties
Click Advanced to display more configuration fields and edit the
details of your dial-in management setup. Click Basic to display fewer
fields.
Enable Select this check box to turn on dial-in management.
Description Enter some information about this connection.
Mute Select this check box to stop the external serial modem from making
audible sounds during a dial-in management session.
Answer Rings Set how many times the ZyWALL lets the incoming dial-in
management session ring before processing it.