ZyXEL Communications USG-100@USG-200 - V2.20 ED 2 - Set up User Groups; Set up User Authentication Using the RADIUS Server

Chapter 7 Tutorials
ZyWALL USG 100/200 Series User’s Guide
150
7.7.2 Set Up User Groups
Set up the user groups and assign the users to the user groups.
1 Click Configuration > Object > User/Group > Group. Click the Add icon.
2 Enter the name of the group that is used in Table 22 on page 148. In this example,
it is “Finance”. Then, select User/Leo and click the right arrow to move him to the
Member list. This example only has one member in this group, so click OK. Of
course you could add more members later.
Figure 103 Configuration > Object > User/Group > Group > Add
3 Repeat this process to set up the remaining user groups.
7.7.3 Set Up User Authentication Using the RADIUS Server
This step sets up user authentication using the RADIUS server. First, configure the
settings for the RADIUS server. Then, set up the authentication method, and
configure the ZyWALL to use the authentication method. Finally, force users to log
in to the ZyWALL before it routes traffic for them.