Chapter 34 IDP
ZyWALL USG 100/200 Series User’s Guide
607
34.2 The IDP General Screen
Click Configuration > Anti-X > IDP > General to open this screen. Use this
screen to turn IDP on or off, bind IDP profiles to traffic directions, and view
registration and signature information.
Note: You must register in order to use packet inspection signatures. See the
Registration screens.
If you try to enable IDP when the IDP service has not yet been registered, a
warning screen displays and IDP is not enabled.
Figure 430 Configuration > Anti-X > IDP > General
The following table describes the screens in this screen.
Table 161 Configuration > Anti-X > IDP > General
LABEL DESCRIPTION
General Settings
Enable
Signature
Detection
You must register for IDP service in order to use packet inspection
signatures. If you don’t have a standard license, you can register for
a once-off trial one.
Policies Use this list to specify which IDP profile the ZyWALL uses for traffic
flowing in a specific direction. Edit the policies directly in the table.
To Next Page
Loading...
