ZyXEL Communications USG-100@USG-200 - V2.20 ED 2 - Default Interface and Zone Configuration

Chapter 6 Configuration Basics
ZyWALL USG 100/200 Series User’s Guide
96
6.2.2 Default Interface and Zone Configuration
This section introduces the ZyWALL’s default zone member physical interfaces and
the default configuration of those interfaces. The following figure uses letters to
denote public IP addresses or part of a private IP address.
Figure 57 Default Network Topology
Table 14 ZyWALL USG 200 Default Port, Interface, and Zone Configuration
PORT INTERFACE ZONE
IP ADDRESS AND DHCP
SETTINGS
SUGGESTED USE WITH
DEFAULT SETTINGS
P1, P2 wan1, wan2 WAN DHCP clients Connections to the Internet
P3 opt OPT None, DHCP server
disabled
Third WAN, additional LAN,
WLAN, or DMZ port or a
separate network.
P4 lan1 LAN1 192.168.1.1, DHCP
server enabled
Protected LAN
P5 lan2 LAN2 192.168.2.1, DHCP
server enabled
Protected LAN
P6 ext-wlan WLAN 10.59.0.1, DHCP server
enabled
Wireless access points
P7 dmz DMZ 192.168.3.1, DHCP
server disabled
Public servers (such as
web, e-mail and FTP)
AUX aux None None Auxiliary modem
CONSOLE n/a None None Local management