ZyXEL Communications USG-100@USG-200 - V2.20 ED 2 - What You Need to Know; IP;MAC Binding Summary

Chapter 22 IP/MAC Binding
ZyWALL USG 100/200 Series User’s Guide
448
22.1.2 What You Need to Know
DHCP
IP/MAC address bindings are based on the ZyWALL’s dynamic and static DHCP
entries.
Interfaces Used With IP/MAC Binding
IP/MAC address bindings are grouped by interface. You can use IP/MAC binding
with Ethernet, bridge, VLAN, and WLAN interfaces. You can also enable or disable
IP/MAC binding and logging in an interface’s configuration screen.
22.2 IP/MAC Binding Summary
Click Configuration > Network > IP/MAC Binding to open the IP/MAC
Binding Summary screen. This screen lists the total number of IP to MAC
address bindings for devices connected to each supported interface.
Figure 332 Configuration > Network > IP/MAC Binding > Summary
The following table describes the labels in this screen.
Table 113 Configuration > Network > IP/MAC Binding > Summary
LABEL DESCRIPTION
Edit Double-click an entry or select it and click Edit to open a screen where
you can modify the entry’s settings.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.