Chapter 8 L2TP VPN Example
ZyWALL USG 100/200 Series User’s Guide
188
• Configure the My Address setting. This example uses interface wan1 with
static IP address 172.16.1.2.
Note: If it is possible that the remote user’s public IP address could be in the same
subnet as the specified My Address, click Configure > Network > Routing >
Policy Route > Show Advanced Settings and select Use Policy Route to
Override Direct Route.
• Select Pre-Shared Key and configure a password. This example uses top-
secret. Click OK.
Figure 154 Configuration > VPN > IPSec VPN > VPN Gateway > Edit
2 Select the Default_L2TP_VPN_GW entry and click Activate and click Apply to
turn on the entry.
Figure 155 Configuration > VPN > IPSec VPN > VPN Gateway (Enable)
To Next Page
Loading...
