Chapter 10 Monitor
ZyWALL USG 100/200 Series User’s Guide
257
To open the station monitor, click Monitor > System Status > WLAN Status.
The screen appears as shown.
Figure 241 Monitor > System Status > WLAN Status
The following table describes the labels in this menu.
Table 39 Monitor > System Status > WLAN Status
LABEL DESCRIPTION
Station
List
Select the location where the IEEE 802.11b/g is located.
# This is the index number of the MAC address.
MAC
Address
This displays the MAC address (in XX:XX:XX:XX:XX:XX format) of a
connected wireless station.
Strength This displays the strength of the wireless client’s radio signal. The signal
strength mainly depends on the antenna output power and the wireless
client’s distance from the ZyWALL.
Connect
Rate
This displays what data transfer rate of the wireless client’s connection to the
ZyWALL. This field displays up to the standard IEEE 802.11g connection rate
of 54 Mbps. It does not display higher, even if you enable super mode. The
display on your wireless clients may vary.
Interface This is the name of the wireless LAN interface on the ZyWALL to which the
wireless client is connected.
Refresh Click this button to update the information in the screen.
To Next Page
Loading...
