Chapter 51 Log and Report
ZyWALL USG 100/200 Series User’s Guide
891
The following table describes the labels in this screen.
Table 258 Configuration > Log & Report > Log Setting > Edit (USB Storage)
LABEL DESCRIPTION
Duplicate logs
to USB storage
(if ready)
Select this to have the ZyWALL save a copy of its system logs to a
connected USB storage device. Use the Active Log section to specify
what kinds of messages to include.
Active Log
Selection Use the Selection drop-down list to change the log settings for all of the
log categories.
disable all logs (red X) - do not send the remote server logs for any log
category.
enable normal logs (green check mark) - send the remote server log
messages and alerts for all log categories.
enable normal logs and debug logs (yellow check mark) - send the
remote server log messages, alerts, and debugging information for all
log categories.
# This field is a sequential value, and it is not associated with a specific
entry.
Log
Category
This field displays each category of messages. The Default category
includes debugging messages generated by open source software.
Selection Select what information you want to log from each Log Category
(except All Logs; see below). Choices are:
disable all logs (red X) - do not log any information from this category
enable normal logs (green check mark) - log regular information and
alerts from this category
enable normal logs and debug logs (yellow check mark) - log regular
information, alerts, and debugging information from this category
OK Click this to save your changes and return to the previous screen.
Cancel Click this to return to the previous screen without saving your changes.
To Next Page
Loading...
