3Com EtherLink 3C509B - Configure ISA Adapter without NetWare

Configuring the ISA Adapter
2-6
Configuring a Single ISA Adapter for an
ISA Computer and a Non-NetWare NOS
To configure the EtherLink III adapter, proceed as follows:
1. Make sure the EtherLink III adapter has been
installed in your ISA computer (refer to Chapter 1
for instructions).
2. Boot your computer under DOS, version 3.1
or later.
3. Place the EtherDisk diskette in a floppy drive on
your computer and make that drive the active
drive. For example:
A: [Enter]
4. Type at the prompt:
INSTALL [Enter]
5. The first time you use the diskette to install an
adapter, a license screen appears. To accept the
terms and conditions of the 3Com end-user
software license agreement, type the following:
Y
NOTE: To view the full text of the license agreement,
press [F1].
The auto installation screen shown in Figure 2-1
appears.