Installing the Network Drivers
6-2
Installing Drivers from the
EtherDisk
Diskette
The EtherDisk diskette contains files and drivers, a utility
program to automatically install some drivers, and software
driver directories that include NDIS and Novell
®
NetWare
drivers. If you used the AutoLink auto installation software
feature for a single ISA or EISA adapter under the
conditions described in Chapters 2 and 3, NetWare DOS
ODI client driver installation was performed automatically,
and no further installation procedures are necessary. If your
situation does not meet the conditions required by the auto
installation feature, follow the steps below to load the
appropriate network driver.
1. Make sure that you have installed and configured
the adapter, and booted the computer under
DOS.
2. If the EtherDisk diskette is already in your floppy
drive, go directly to step 7. Otherwise, insert the
EtherDisk diskette in a floppy drive on your
computer.
3. Make that drive the current drive.
For example, if the diskette drive is A, type the
following command:
A: [Enter]
4. Type at the prompt:
INSTALL [Enter]
To Next Page
Loading...
Need help?
General
