Configuring the EISA Adapter 3-7
2. Insert the EtherDisk diskette in a floppy drive on your
computer and make that drive the current drive.
For example, if the diskette drive is A, type the
following command:
A: [Enter]
3. Type at the prompt:
INSTALL [Enter]
4. The first time you use the diskette to install an
adapter, a license screen appears. To accept the
terms and conditions of the 3Com end-user
software license agreement, type the following:
Y
NOTE: To view the full text of the license agreement,
press [F1].
The auto installation screen shown in Figure 3-1 appears.
Figure 3-1. Auto Installation Screen
To Next Page
Loading...
