Installing the Network Drivers 6-5
NetWare 4.x Server Drivers
The EtherDisk diskette contains a NetWare 4.x server driver
and four NetWare Loadable Modules (NLMs) that enable
the NetWare 4.x driver to be used with NetWare 3.11
software. These NLMs are:
– LSLENH.NLM
– PATCHMAN.NLM
– MSM31X.NLM
– ETHERTSM.NLM
To load the 4.x server driver while running NetWare 3.11,
enter the following commands in the order shown below.
These files must all be copied to the same subdirectory.
If you are not loading them from the SYSTEM volume,
you must supply the DRIVEID:\PATH to the location of
the files.
load LSLENH.NLM [Enter]
load 3C5X9.LAN [Enter]
If this order is not followed, the system will not operate
correctly. LSLENH.NLM loads itself and
PATCHMAN.NLM. 3C5X9.LAN loads itself,
MSM31X.NLM, and ETHERTSM.NLM. When this has
been done, bind the protocol to the driver as usual.
NOTE: When running the 3C5X9.LAN driver with
NetWare 3.11, you must update the MONITOR.NLM file
that accompanied NetWare 3.11 with the MONITOR.NLM
file on the EtherDisk diskette in the directory
\NETWARE\SRV311\. This is done automatically during
installation.
To Next Page
Loading...
Need help?
General
