3Com EtherLink 3C509B User Manual

Configuring the ISA Adapter 2-3
Auto Installing a Single ISA Adapter for
an ISA Computer and a NetWare NOS
EtherLink III adapters 3C509, 3C509-TP, and
3C509-COMBO are ISA adapters. If you are not sure
what type of adapter you have, refer to Figure 1-1 and
Table 1-1.
To use 3Com’s AutoLink auto installation software
feature for a NetWare client, perform these steps:
1. Make sure that you have booted the computer
under DOS, version 3.1 or later, and your computer
is connected to the network (see Chapter 5).
2. Insert the EtherDisk diskette in a floppy drive on
your computer and make that drive the current
drive.
For example, if the diskette drive is A, type the
following command:
A: [Enter]
3. Type at the prompt:
INSTALL [Enter]
4. The first time you use the diskette to install an
adapter, a license screen appears. To accept the
terms and conditions of the 3Com end-user
software license agreement, type the following:
Y

3Com EtherLink 3C509B Specifications

General

Brand	3Com
Model	EtherLink 3C509B
Category	Adapter
Language	English