3Com EtherLink 3C509B - Configure EISA Computer for Adapter

Configuring the EISA Adapter
3-2
This chapter consists of the following sections:
■ Configuring the EISA Computer to Accept an EISA
Adapter
■ Changing Software Option Settings
■ Auto Installing the EISA Adapter for a NetWare NOS
Once you have configured the EISA computer to accept the
adapter, you can start the auto installation procedure from
the EtherDisk diskette if your network environment meets
the following requirements:
■ Your network operating system must be NetWare 2.x,
3.1x, or 4.x.
■ Your computer must have an 80286 or higher processor.
■ Your computer must have only one EtherLink III
adapter installed in it.
■ Your computer must be intended for use as a DOS ODI
client.
Configuring the EISA Computer to
Accept an EISA Adapter
To configure the EISA computer to accept the EISA
adapter, perform the following steps:
1. Install the EtherLink III adapter in your EISA
computer (refer to Chapter 1 for instructions).
2. Insert the EISA configuration diskette provided
with your computer into drive A.
3. Turn the power switch on.