EasyManuals Logo

3Com EtherLink 3C509B User Manual

3Com EtherLink 3C509B
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
Configuring the ISA Adapter 2-1
Chapter 2
Configuring the ISA Adapter
This chapter explains how to configure an EtherLink III
ISA adapter installed in an ISA computer. The section
“Auto Installing a Single ISA Adapter for an ISA
Computer and a NetWare NOS” explains how to use the
AutoLink
auto installation software feature of the
EtherDisk diskette to configure your EtherLink III
adapter and install the required drivers. To use the
AutoLink software feature, you must meet the following
requirements:
Your network operating system (NOS) must be
NetWare 2.x, 3.1x, or 4.x.
Your computer must have an 80286 or higher
processor.
Your computer must have only one EtherLink III
adapter installed in it.
Your computer must be intended for use as a DOS
ODI client.
If this does not describe your network environment, refer
to the subsequent sections of this chapter to configure
your EtherLink III adapter. EtherLink III adapters have
an auto configuration utility that properly configures an
adapter in most situations. For typical installations, refer
to one of the following sections:
Configuring a Single ISA Adapter for an ISA
Computer and a Non-NetWare NOS

Table of Contents

Other manuals for 3Com EtherLink 3C509B

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the 3Com EtherLink 3C509B and is the answer not in the manual?

3Com EtherLink 3C509B Specifications

General IconGeneral
Brand3Com
ModelEtherLink 3C509B
CategoryAdapter
LanguageEnglish

Related product manuals