Performing Troubleshooting and Diagnostic Tests 7-15
3. Start the diagnostic program on the echo server.
The diagnostic program that you use depends upon the
adapter board that is installed in the echo server.
After the system prompt of the drive containing the
Configuration and Diagnostic Program, enter the name
of the appropriate program from the following list:
Diagnostic
Program Name Adapter
3C503 EtherLink II
®
or II TP,
EtherLink II/16 or
II/16 TP
3C505 EtherLink Plus
®
3C507 EtherLink 16 or
EtherLink 16 TP
3C5X9CFG All EtherLink III
adapters
3C523 EtherLink/MC
3C523TP EtherLink/MC TP
3C527 EtherLink/MC 32
The diagnostic programs listed above come on the
EtherDisk diskette that accompanied the adapter.
4. From the main menu, select Echo Server Setup.
The program notifies you that your computer is now
set up as an echo server.
To Next Page
Loading...
Need help?
General
