703D SYSTEMS, INC. PN:80-D27 Rev.B
Parts:
• 1x kit “Disposable Process Filter” (part number : 151605), including :
• 1x lter vessel in closed state, with closing set mounted on it: 2x clamps (1), 2x cover lids (2), 2x centering rings with
stand-off (3)
• 2x standard centering rings (4)
• ADR stickers (European Agreement concerning the International Carriage of Dangerous Goods by Road). The
sticker must be applied on the lter vessel before shipping it to waste management.
- ADR 4.2: apply when lter is full with Ti fumes
- ADR 9: apply when lter is full with Ni or Co containing fumes
• 2x cover lids that have been kept aside during the used process lter installation. They will be used to close the lter
during the replacement. The procedure will indicate to store it for later use.
Caution: the clean lter vessel is lled with argon to avoid water condensation during transportation.
WARNING: OPEN NEW FILTER VESSEL ONLY AT THE MOMENT OF CONNECTION TO MACHINE. KEEP OPEN
TIME TO ABSOLUTE MINIMUM.
WARNING: ALWAYS LEAVE DIRTY FILTER VESSELS FIRMLY CLOSED AND MARK CLEARLY THAT IT CONTAINS
EX AND FLAMMABLE SOLIDS AND/OR ENVIRONMENTALLY HAZARDOUS SUBSTANCES USING THE PROVIDED
ADR LABELS. STORE DIRTY FILTER VESSELS IN A SAFE LOCATION WITHOUT THE RISK OF BEING DAMAGED
OR OPENED BY UNAUTHORIZED PEOPLE.
WARNING: DO NOT START THE LENS CLEANER BLOWER WHILE THE PROCESS FILTER IS NOT CONNECTED TO
THE PRINTER.
Tools:
• Permanent marker
• 10mm wrench
• 5mm Allen wrench
2
1
3
4
To Next Page
Loading...
Need help?
General
