3DHISTECH Pannoramic 250 - Page 61

Pannoramic 250 1.15 User’s Guide 4 Software Description
Figure 37 – Not scanned selection
TMA tool
TMA tool is used for selecting TMA spots on TMA slides. You can set the selection settings
on the following four tabs:
Select tab panel
Figure 38 – TMA tool: Select
• To create a new TMA object, click New.
• To select an existing TMA object, click on the object name. The selected object
name will highlight.
• To delete an existing TMA object, click Delete.
March 13, 2012 – Rev. 1 3DHISTECH Ltd.
61(135)