ABB ACS880-104

Parameters 235
Fieldbus A The start and stop commands are taken from fieldbus adapter
A.
Note: The start signal is always level-triggered with this
setting regardless of parameter 20.02 Ext1 start trigger type.
12
Embedded fieldbus The start and stop commands are taken from the embedded
fieldbus interface.
Note: The start signal is always level-triggered with this
setting regardless of parameter 20.02 Ext1 start trigger type.
14
M/F link The start and stop commands are taken from another drive
through the master/follower link.
Note: The start signal is always level-triggered with this
setting regardless of parameter 20.02 Ext1 start trigger type.
15
Application
Program
The start and stop commands are taken from the application
program control word (parameter 06.02 Application control
word).
Note: The start signal is always level-triggered with this
setting regardless of parameter 20.02 Ext1 start trigger type.
21
ATF Reserved. 22
DDCS controller The start and stop commands are taken from an external
(DDCS) controller.
Note: The start signal is always level-triggered with this
setting regardless of parameter 20.02 Ext1 start trigger type.
16
20.02 Ext1 start trigger
type
Defines whether the start signal for external control location
EXT1 is edge-triggered or level-triggered.
Note: This parameter is only effective when parameter 20.01
Ext1 commands is set to In1 Start, In1 Start; In2 Dir, In1 Start
fwd; In2 Start rev, or Control panel.
Edge
Edge The start signal is edge-triggered. 0
Level The start signal is level-triggered. 1
20.03 Ext1 in1 source Selects source 1 for parameter 20.01 Ext1 commands. DI1
Not selected 0 (always off). 0
Selected 1 (always on). 1
DI1 Digital input DI1 (10.02 DI delayed status, bit 0). 2
DI2 Digital input DI2 (10.02 DI delayed status, bit 1). 3
DI3 Digital input DI3 (10.02
DI delayed status, bit 2). 4
DI4 Digital input DI4 (10.02 DI delayed status, bit 3). 5
DI5 Digital input DI5 (10.02 DI delayed status, bit 4). 6
DI6 Digital input DI6 (10.02 DI delayed status, bit 5). 7
DIO1 Digital input/output DIO1 (11.02 DIO delayed status, bit 0). 10
DIO2 Digital input/output DIO2 (11.02 DIO delayed status, bit 1). 11
Other [bit] Source selection (see Terms and abbreviations on page 148). -
20.04 Ext1 in2 source Selects source 2 for parameter 20.01 Ext1 commands.
For the available selections, see parameter 20.03 Ext1 in1
source.
Not selected
20.05 Ext1 in3 source Selects source 3 for parameter 20.01 Ext1 commands.
For the available selections, see parameter 20.03 Ext1 in1
source.
Not selected
No. Name/Value Description Def/FbEq16