ABB ACS880-104

444 Parameters
81.40 Cleaning abort
source
Defines source for the cleaning abort command.
The cleaning operation can be interrupted at any time with
abort command. In such case, ESP control program will
immediately switch to production mode.
Not selected
Not selected Cleaning abort source is not selected. 0
Selected Cleaning abort source is selected. 1
DI1 Digital input DI1 (10.02 DI delayed status, bit 0). 2
DI2 Digital input DI2 (10.02 DI delayed status, bit 1). 3
DI3 Digital input DI3 (10.02 DI delayed status, bit 2). 4
DI4 Digital input DI4 (10.02 DI delayed status, bit 3). 5
DI5 Digital input DI5 (10.02 DI delayed status, bit 4). 6
DI6 Digital input DI6 (10.02 DI delayed status, bit 5). 7
DIO1 Digital input/output DIO1 (11.02 DIO delayed status, bit 0). 8
DIO2 Digital input/output DIO2 (11.02 DIO delayed status, bit 1). 9
Other Source selection (see Terms and abbreviations on page 148). -
81.41 Supervision low
signal src
Defines the source for the supervision low signal.
The value from this parameter is then compared with the limit
set in parameter 81.42 Supervision low limit. If the observed
signal is lower than the limit for the time period set in
parameter 81.43 Supervision low delay, then cleaning
procedure is interrupted. The ESP control program will
immediately switch to production mode. The supervision low
is not active during off-time period.
Note: For the supervision low function to work, parameter
81.02 Pump cleaning option sel bit-11 must be set to 1.
Motor
current%
NULL Zero 0
AI1 scaled See parameter 12.12 AI1 scaled value (see page 197). 1
AI2 scaled See parameter 12.22 AI2 scaled value (see page 199). 2
FBA1 ref See parameter 03.05 FB A reference 1 (page 156
). 3
FBA2 ref See parameter 03.06 FB A reference 2 (page 156). 4
EFB1 ref See parameter 03.09 EFB reference 1 (page 156). 5
EFB2 ref See parameter 03.10 EFB reference 2 (page 156). 6
Estimated motor
current
Parameter 09.13 Motor current estimated (see page 183). 7
Motor current% Estimated motor current in % of nominal motor current. 8
Other Source selection (see Terms and abbreviations on page 148). -
81.42 Supervision low
limit
Defines low limit value for the Supervision low function.
See parameter 81.41 Supervision low signal src.
0.00
0.00...30000.00 Supervision low limit. 10 = 1
81.43 Supervision low
delay
Defines delay time for the Supervision low function.
See parameter 81.41 Supervision low signal src.
10.0
0.0...3200.0 s Supervision low delay. 10 = 1s
No. Name/Value Description Def/FbEq16