INSTALLATION PROCEDURES
82 FOX615Installation
The steps to install the front cover on the subrack are as follows:
Front cover installation Proceed as follows:
1. Hinge the lower lids (1) of the front cover into the slots of the left and
right side earthing bars (2) and press (A) it firmly into the slots.
2. Rotate the front cover towards the front of the subrack (3) while applying
a constant force (B) in the direction of the earthing bar.
3. Glide the left hand and the right hand locks into the slots in the subrack
(4).
4. Align the upper lids of the front cover to the slotted rail at the upper edge
of the subrack (5).
5. Close the cover firmly (C). Listen for the clicks of the right and left hand
locks (6).
6. Check the cover for correct fitting.
End of instruction
To Next Page
Loading...