ABB FOX615 - Associated documents of standard bodies; Declaration of conformity

ANNEX
92 FOX615Installation
5.2 Associated documents of standard bodies
5.3 Declaration of conformity
EC Declaration of Conformity
The FOX products as listed below
• FOX615 Subrack
•FOX FAMO1
•FOX FAMO1-F
•FOX DUPF1
• FOX Control Unit(s) as stated in the applicable release notes
• FOX Service Units as stated in the applicable release notes
if used for the intended purpose, correctly installed and operated according
to the applicable user manuals, comply with the European Directives as fol-
lows:
Conformity to the previously mentioned EC directive is proven for complete
compliance to the following harmonised standards:
Table 16: Associated documents of standard bodies
Body Standard Title
ETSI EN 300 132-2 Equipment Engineering (EE);
Power Supply Interface at the Input to Tele-
communications Equipment; Operated by
Direct Current (DC)
ETSI ETSI EN 300 253 V2.1.1 Environmental Engineering (EE):
Earthing and bonding configuration inside tele-
communication centres
IEC IEC/EN 61000-4-2 Electromagnetic compatibility (EMC)
Part 4-2:
Testing and measurement techniques
Electrostatic discharge immunity test
Standard Title
2004/108/EC Electromagnetic Compatibility Directive
2006/95/EC Low Voltage Directive
Standard Title
ETSI EN 300 386
V1.3.3
Electromagnetic compatibility and Radio spectrum Matters
(ERM); Telecommunication network equipment; Electro-
Magnetic Compatibility (EMC) requirements
EN 60950-1
(2006)
Information technology equipment - Safety — Part 1: Gen-
eral requirements