6146/6156 DC Voltage/Current Generators Operation Manual
5.1.2 Compatibility
5-4
Command unavailable in the 6144-compatible mode
Commands whose functions change in the 6144-compatible mode
For more information on operational differences in the 6144-compatible mode, refer to the following sec-
tions.
5.7 Source Value Output Format (Talker Format)
5.8.3 Remote Command List
5.8.4 6144-compatible Remote Command List
Command Function
*SRE Sets the Service Request Enable Register
*SRE? Query of the Service Request Enable Register
*ESR? Query of the Standard Event Status Register (ESR)
*ESE Sets the Standard Event Status Enable Register
*ESE? Query of the Standard Event Status Enable Register
DSR? Query of the Device Event Status Resister (DSR)
DSE Sets the Device Event Status Enable Resister
DSE? Query of the Device Event Status Enable Resister
*CLS Clears the status
Command Function
D? Query of the source value
For the 6156, the lowest digit is not read in the compatible mode.
SC Sets the first number and the last number of memory scan.
The available memory number is 0 to 159 in the compatible mode.
SC? Query of the first number and the last number of memory scan
A space is inserted between the first number and the last number in the compatible
mode.
C/C0 Clears the device.
Clears the device and initializes the parameters in the compatible mode.
However, remote sense and limit value are not initialized.(For software revision B00
or later)
D±data[unit] For the 6146, the lowest digit is rounded off to an even number in the 30 V range in
the compatible mode.
When the source value is set with the auto range set to ON, the range is selected in
conformity to the 6144.
For more information, refer to 6144 Programmable DC Voltage/Current Generator
Operation Manual.
When the count fix function is set to ON in the compatible mode, the count value
becomes the same for both voltage and current by switching between voltage source
and current source.
The count fix function is set to ON as default in the compatible mode.