7351 Series Digital Multimeter Operation Manual
6.7 Command Reference
6-16
6.7 Command Reference
This section describes the command reference of this instrument.
6.7.1 Selecting the Command Language
This instrument can be operated remotely by using the following commands.
The command selection procedure is shown below.
1. Select the category from the mode and press to enter the
selection layer.
2. Select the LANG parameter by pressing and , and press to enter in the
entry layer.
3. Select from SCPI, ADC, and R6451 by pressing and , and press
to apply the setting.
SCPI: SCPI Command
ADC: Command used in ADC CORPORATION
R6451: Command used in ADC CORPORATION's R6451
For more information on operations, refer to “R6451 Series Dig-
ital Multimeter Operation Manual”.
To Next Page
Loading...
Need help?
General
