7351 Series Digital Multimeter Operation Manual
8.5 Product Disposal and Recycle
8-12
8.5 Product Disposal and Recycle
Disposal of this product should comply with the regulations and laws that are established by your country
and municipality.
When treating this product, separately collect components according to this chapter to prevent the spread of
substances, which may be harmful to humans, and to protect the global environment.
Components, which must be separately collected, are shown in the following table.
The treatment of this product should comply with the relevant laws of your country and waste-disposal reg-
ulations of your company.
Substance/Component
Used/
Not used
Location Unit Component
Quantity in
maximum
configuration
Polychlorinated biphenyls
(PCB) containing capacitors
Not used - - - -
Mercury containing compo-
nents
Not used - - - -
Batteries Not used - - - -
Printed circuit boards Used Main frame MAIN Printed circuit board 1
Toner cartridges Not used - - - -
Plastic containing bromi-
nated flame retardants
Used Main frame BPL-032930 Connector, diode,
zener diode, optocou-
pler, FET, analog IC,
logic IC, FLASH, and
transistor
18
BPL-033237
Asbestos waste and compo-
nents which contain asbes-
tos
Not used - - - -
Cathode ray tubes Not used - - - -
Chlorofluorocarbons (CFC),
Hydrochlorofluorocarbons
(HCFC), Hydrofluorocar-
bons (HFC) or Hydrocar-
bons (HC)
Not used - - - -
Gas discharge lamps Not used - - - -
Liquid crystal displays of a
surface greater than 100
square centimeters
Not used - - - -
External electric cables Used Main frame Power cable 1
Input probe 2
Components containing
refractory ceramic fibers
Not used - - - -
To Next Page
Loading...
Need help?
General
